CEV65M-50034, TR Deere Encoder Domestic Replacement Solution with Customization Process (171-50034)

This is a TRDIEHL Encoders, today is about the customization of domestic alternatives.

The model CEV65M-50034 has been commissioned by 6 customers in the past year for customized replacement business. InDIEHL EncodersCustomization in the business is considered to be more of a model. The customized replacement of this product mainly involves some aluminum factories, steel mills, this kind of enterprise is more.

In practice, one customer was not able to use it properly. The reason was that the customer did not know how to use the GSD file of the Profibus encoder, and there was no way out of this situation. For profibus encoders, it is necessary to know how to use the GSD file.

If you can't use the GSD file and can't use it in configuration, be careful. Especially for some traders, it is important to communicate with customers well in advance. Although, this is all some basic operation, still need to confirm it first. This will save a lot of time.

Introduction to the localization programme

Let's link to the parameterization of this encoder.

Through the manual, we know that this is a profibus communication multi-turn absolute encoder, shaft diameter 7mm, square flange 80mm. Shaft diameter 7mm, square flange 80mm, this encoder alternative focus is the square flange, because the square flange is less, so similar alternative can choose space is much smaller.

We make the hardware with consistent mounting dimensions by machining, and customize the internal machinery accordingly to the parameters. In this way, a complete replacement program is created.

Here, we take a look at how the replacement product looks:

From the picture, we can roughly see how this product looks like. It is 1:1 in terms of mounting dimensions. Feedback from customers on the application is generally good, only the one that can't apply it is inoperable, the rest of the few have very good feedback.

Customization Process

If the product is customized just for this model, there is no need for too much process. Just a simple communication is all that is needed, after all, this is a mature product. As long as there is a technician on duty, it will be fine.

If traders, be sure to communicate first if the customer will use it. This will save each other's time cost. As a customized product, we would like to apply it to scenarios where we have the ability to operate the technology.

If, you have a need for this you can contact me. The contact details at the bottom of the article can be used to get in touch with me.